Tsunami problems

[Jayce]

I posted this on general but figured it's more of a technical problem so here it is.

RE SE 15, 1.5 sealed, JBL 600.1, nice excursion hella bass..

I drop the JBL pick up the Tsunami DB1100

at 2 ohm that amp pushes 650 "true watts" from what I understand

my sub is fine, wired paralle, for 2 ohm load

it feels like 40 rms, the sub barely moves 1mm, 2 mm if I'm lucky

Would it make a diff to run each VC to the set of terminals? It has 2 sets of terminals, just as 2 channel amp would, however it's a mono amp. would I get better results doing that??

btw, all settings are fine...

gain is up
SSF off
LPF 85
remote unplugged
grounded properly
lights up like it should
this is where I get lost...

[formulator]

Are you sure the gain is properly adjusted and the sub is wired correctly?

connecting it to the amp in different ways like you said will not help, those terminals are internally connected (positives together, negatives together), mono means 1.

Make sure you have the sub wired correctly and not out of phase and make sure the gain and x-over are properly set. Other than that I'm not sure what ese could be the problem.

[Vincent]

Check your wiring.

Try another sub.

Troubleshoot ;)